Non-volatile memory (NVM) or non-volatile storage is a type of computer memory that can retain stored information even after power is removed. In contrast, volatile memory needs constant power in order to retain data.
Non-volatile memory typically refers to storage in semiconductor memory chips, which store data in floating-gate memory cells consisting of floating-gate MOSFETs (metal–oxide–semiconductor field-effect transistors), including flash memory storage such as NAND flash and solid-state drives (SSD).
Other examples of non-volatile memory include read-only memory (ROM), EPROM (erasable programmable ROM) and EEPROM (electrically erasable programmable ROM), ferroelectric RAM, most types of Computer data storage devices (e.g. disk storage, hard disk drives, optical discs, floppy disks, and magnetic tape), and early computer storage methods such as punched tape and cards.
Non-volatile memory is typically used for the task of secondary storage or long-term persistent storage. The most widely used form of primary storage today is a volatile form of random access memory (RAM), meaning that when the computer is shut down, anything contained in RAM is lost. However, most forms of non-volatile memory have limitations that make them unsuitable for use as primary storage. Typically, non-volatile memory costs more, provides lower performance, or has a limited lifetime compared to volatile random access memory.
Non-volatile data storage can be categorized into electrically addressed systems (read-only memory) and mechanically addressed systems (hard disks, optical disc, magnetic tape, holographic memory, and such). Generally speaking, electrically addressed systems are expensive, have limited capacity, but are fast, whereas mechanically addressed systems cost less per bit, but are slower.
Electrically addressed semiconductor non-volatile memories can be categorized according to their write mechanism. Mask ROMs are factory programmable only, and typically used for large-volume products which are not required to be updated after manufacture. Programmable read-only memory can be altered after manufacture, but require a special programmer and usually cannot be programmed while in the target system. The programming is permanent and further changes require replacement of the device. Data is stored by physically altering (burning) storage sites in the device.
An EPROM is an erasable ROM that can be changed more than once. However, writing new data to an EPROM requires a special programmer circuit. EPROMs have a quartz window that allows them to be erased with ultraviolet light, but the whole device is cleared at one time. A one-time programmable (OTP) device may be implemented using an EPROM chip without the quartz window; this is less costly to manufacture. An electrically erasable programmable read-only memory EEPROM uses voltage to erase memory. These erasable memory devices require a significant amount of time to erase data and to write new data; they are not usually configured to be programmed by the processor of the target system. Data is stored by use of floating-gate transistors which require special operating voltages to trap or release electric charge on an insulated control gate to store information.
Flash memory is a solid-state chip that maintains stored data without any external power source. It is a close relative to the EEPROM; it differs in that erase operations must be done on a block basis and capacity is substantially larger than that of an EEPROM. Flash memory devices use two different technologies—NOR and NAND���to map data. NOR flash provides high-speed random access, reading and writing data in specific memory locations; it can retrieve as little as a single byte. NAND flash reads and writes sequentially at high speed, handling data in blocks, however it is slower on read when compared to NOR. NAND flash reads faster than it writes, quickly transferring whole pages of data. Less expensive than NOR flash at high densities, NAND technology offers higher capacity for the same-size silicon.
Ferroelectric RAM (F-RAM)
Ferroelectric RAM (FeRAM, F-RAM or FRAM) is a form of random-access memory similar in construction to DRAM, both use a capacitor and transistor but instead of using a simple dielectric layer the capacitor, a F-RAM cell contains a thin ferroelectric film of lead zirconate titanate [Pb(Zr,Ti)O
3], commonly referred to as PZT. The Zr/Ti atoms in the PZT change polarity in an electric field, thereby producing a binary switch. Due to the PZT crystal maintaining polarity, F-RAM retains its data memory when power is shut off or interrupted.
Due to this crystal structure and how it is influenced, F-RAM offers distinct properties from other nonvolatile memory options, including extremely high, although not infinite, endurance (exceeding 1016 read/write cycles for 3.3 V devices), ultra low power consumption (since F-RAM does not require a charge pump like other non-volatile memories), single-cycle write speeds, and gamma radiation tolerance.
Magnetoresistive RAM (MRAM)
Magnetoresistive RAM stores data in magnetic storage elements called magnetic tunnel junctions (MTJs). The first generation of MRAM, such as Everspin Technologies' 4 Mbit, utilized field-induced writing. The second generation is developed mainly through two approaches: Thermal-assisted switching (TAS) which is being developed by Crocus Technology, and Spin-transfer torque (STT) which Crocus, Hynix, IBM, and several other companies are developing.[when?]
Mechanically addressed systems
Mechanically addressed systems use a recording head to read and write on a designated storage medium. Since the access time depends on the physical location of the data on the device, mechanically addressed systems may be sequential access. For example, magnetic tape stores data as a sequence of bits on a long tape; transporting the tape past the recording head is required to access any part of the storage. Tape media can be removed from the drive and stored, giving indefinite capacity at the cost of the time required to retrieve a dismounted tape.
Hard disk drives use a rotating magnetic disk to store data; access time is longer than for semiconductor memory, but cost per stored data bit is very low, and they provide random access to any location on the disk. Formerly, removable disk packs were common, allowing storage capacity to be expanded. Optical discs store data by altering a pigment layer on a plastic disk, and are similarly random access. Read-only and read-write versions are available; removable media again allows indefinite expansion, and some automated systems (e.g. optical jukebox) were used to retrieve and mount disks under direct program control.
Thinfilm produces rewriteable non-volatile organic ferroelectric memory based on ferroelectric polymers. Thinfilm successfully demonstrated roll-to-roll printed memories in 2009. In Thinfilm's organic memory the ferroelectric polymer is sandwiched between two sets of electrodes in a passive matrix. Each crossing of metal lines is a ferroelectric capacitor and defines a memory cell.
Non-volatile main memory
- Patterson, David; Hennessy, John (1971). Computer Organization and Design: The Hardware/Software Interface. Elsevier. p. 23. ISBN 9780080502571.
- "i-NVMM: Securing non-volatile memory on the fly". Techrepublic. Archived from the original on 22 March 2017. Retrieved 21 March 2017.
- "Non-Volatile Memory (NVM)". Techopedia. Archived from the original on 22 March 2017. Retrieved 21 March 2017.
- Russell Kay (7 June 2010). "Flash memory". ComputerWorld. Archived from the original on 10 June 2010.
- F-RAM Memory Technology, Ramtron.com, archived from the original on 27 January 2012, retrieved 30 January 2012
- The Emergence of Practical MRAM "Crocus Technology | Magnetic Sensors | TMR Sensors" (PDF). Archived from the original (PDF) on 27 April 2011. Retrieved 20 July 2009.
- "Latest News". EE|Times. Archived from the original on 19 January 2012.
- "Definition: tape drive". TechTarget. Archived from the original on 7 July 2015. Retrieved 7 July 2015.
- "Tape Drives". snia.org. Archived from the original on 7 July 2015. Retrieved 7 July 2015.
- "What is hard drive?". computerhope.com. Archived from the original on 8 July 2015. Retrieved 7 July 2015.
- "IBM 2314 Disk Drives". ncl.ac.uk. Archived from the original on 2 October 2015. Retrieved 7 July 2015.
- "Optical Blu-ray Jukeboxes and Libraries Systems for Archiving Storage - Kintronics". kintronics.com. Archived from the original on 20 July 2015. Retrieved 7 July 2015.
- Thinfilm and InkTec awarded IDTechEx' Technical Development Manufacturing Award IDTechEx, 15 April 2009
- PolyIC, ThinFilm announce pilot of volume printed plastic memories Archived 29 September 2012 at the Wayback Machine EETimes, 22 September 2009
- All set for high-volume production of printed memories Archived 13 April 2010 at the Wayback Machine Printed Electronics World, 12 April 2010
- "NVDIMM – Changes are Here, So What's Next?" (PDF). snia.org. SINA. Retrieved 24 April 2018.
- Security Vulnerabilities of Emerging Nonvolatile Main Memories and Countermeasures
- Supporting filesystems in persistent memory, LWN.net, 2 September 2014, by Jonathan Corbet
- Research paper about perspective usage of magnetic photoconductors in magneto-optical data storage.