|Extremely high frequency (ITU)|
|30 to 300 GHz|
|Millimetre band (IEEE)|
|110 to 300 GHz|
|2.73 to 1 mm|
Extremely high frequency (EHF) is the International Telecommunication Union (ITU) designation for the band of radio frequencies in the electromagnetic spectrum from 30 to 300 gigahertz (GHz). It lies between the super high frequency band and the far infrared band, the lower part of which is the terahertz band. Radio waves in this band have wavelengths from ten to one millimetre, so it is also called the millimetre band and radiation in this band is called millimetre waves, sometimes abbreviated MMW or mmWave. Millimetre-length electromagnetic waves were first investigated by Indian physicist Jagadish Chandra Bose during 1894–1896, when he reached up to 60 GHz in his experiments.
Compared to lower bands, radio waves in this band have high atmospheric attenuation: they are absorbed by the gases in the atmosphere. Therefore, they have a short range and can only be used for terrestrial communication for distances up to about a kilometer. Absorption increases with frequency until at the top end of the band the waves are attenuated to zero within a few meters. Absorption by humidity in the atmosphere is significant except in desert environments, and attenuation by rain (rain fade) is a serious problem even over short distances. However the short propagation range allows smaller frequency reuse distances than lower frequencies. The short wavelength allows modest size antennas to have a small beam width, further increasing frequency reuse potential. Millimeter waves are used for military fire-control radar, airport security scanners, short range wireless networks, and scientific research.
In a major new application of millimeter waves, certain frequency ranges near the bottom of the band are being used in the newest generation of cell phone networks, 5G networks. The design of millimeter-wave circuit and subsystems (such as antennas, power amplifiers, mixers and oscillators) also presents severe challenges to engineers due to semiconductor and process limitations, model limitations and poor Q factors of passive devices.
Millimeter waves propagate solely by line-of-sight paths. They are not reflected by the ionosphere nor do they travel along the Earth as ground waves as lower frequency radio waves do. At typical power densities they are blocked by building walls and suffer significant attenuation passing through foliage. Absorption by atmospheric gases is a significant factor throughout the band and increases with frequency. However, this absorption is maximum at a few specific absorption lines, mainly those of oxygen at 60 GHz and water vapor at 24 GHz and 184 GHz. At frequencies in the "windows" between these absorption peaks, millimeter waves have much less atmospheric attenuation and greater range, so many applications use these frequencies. Millimeter wavelengths are the same order of size as raindrops, so precipitation causes additional attenuation due to scattering (rain fade) as well as absorption. The high free space loss and atmospheric absorption limit useful propagation to a few kilometers. Thus, they are useful for densely packed communications networks such as personal area networks that improve spectrum utilization through frequency reuse.
Millimeter waves show "optical" propagation characteristics and can be reflected and focused by small metal surfaces and dielectric lenses around 5 to 30 cm (2 inches to 1 foot) diameter. Because their wavelengths are often much smaller than the equipment that manipulates them, the techniques of geometric optics can be used. Diffraction is less than at lower frequencies, although millimeter waves can be diffracted by building edges. At millimeter wavelengths, surfaces appear rougher so diffuse reflection increases. Multipath propagation, particularly reflection from indoor walls and surfaces, causes serious fading. Doppler shift of frequency can be significant even at pedestrian speeds. In portable devices, shadowing due to the human body is a problem. Since the waves penetrate clothing and their small wavelength allows them to reflect from small metal objects they are used in millimeter wave scanners for airport security scanning.
This band is commonly used in radio astronomy and remote sensing. Ground-based radio astronomy is limited to high altitude sites such as Kitt Peak and Atacama Large Millimeter Array (ALMA) due to atmospheric absorption issues.
Satellite-based remote sensing near 60 GHz can determine temperature in the upper atmosphere by measuring radiation emitted from oxygen molecules that is a function of temperature and pressure. The ITU non-exclusive passive frequency allocation at 57–59.3 GHz is used for atmospheric monitoring in meteorological and climate sensing applications and is important for these purposes due to the properties of oxygen absorption and emission in Earth's atmosphere. Currently operational U.S. satellite sensors such as the Advanced Microwave Sounding Unit (AMSU) on one NASA satellite (Aqua) and four NOAA (15–18) satellites and the special sensor microwave/imager (SSMI/S) on Department of Defense satellite F-16 make use of this frequency range.
In the United States, the band 36.0–40.0 GHz is used for licensed high-speed microwave data links, and the 60 GHz band can be used for unlicensed short range (1.7 km) data links with data throughputs up to 2.5 Gbit/s. It is used commonly in flat terrain.
The 71–76, 81–86 and 92–95 GHz bands are also used for point-to-point high-bandwidth communication links. These higher frequencies do not suffer from oxygen absorption, but require a transmitting license in the US from the Federal Communications Commission (FCC). There are plans for 10 Gbit/s links using these frequencies as well. In the case of the 92–95 GHz band, a small 100 MHz range has been reserved for space-borne radios, limiting this reserved range to a transmission rate of under a few gigabits per second.
The band is essentially undeveloped and available for use in a broad range of new products and services, including high-speed, point-to-point wireless local area networks and broadband Internet access. WirelessHD is another recent technology that operates near the 60 GHz range. Highly directional, "pencil-beam" signal characteristics permit different systems to operate close to one another without causing interference. Potential applications include radar systems with very high resolution.
Uses of the millimeter wave bands include point-to-point communications, intersatellite links, and point-to-multipoint communications. There are tentative plans to use millimeter waves in future 5G mobile phones. In addition, use of millimeter wave bands for vehicular communication is also emerging as an attractive solution to support (semi-)autonomous vehicular communications.
Shorter wavelengths in this band permit the use of smaller antennas to achieve the same high directivity and high gain as larger ones in lower bands. The immediate consequence of this high directivity, coupled with the high free space loss at these frequencies, is the possibility of a more efficient use of frequencies for point-to-multipoint applications. Since a greater number of highly directive antennas can be placed in a given area, the net result is greater frequency reuse, and higher density of users. The high usable channel capacity in this band might allow it to serve some applications that would otherwise use fiber-optic communication.
Millimeter wave radar is used in short-range fire-control radar in tanks and aircraft, and automated guns (CIWS) on naval ships to shoot down incoming missiles. The small wavelength of millimeter waves allows them to track the stream of outgoing bullets as well as the target, allowing the computer fire control system to change the aim to bring them together.
With Raytheon the U.S. Air Force has developed a nonlethal antipersonnel weapon system called Active Denial System (ADS) which emits a beam of millimeter radio waves with a wavelength of 3 mm (frequency of 95 GHz). The weapon causes a person in the beam to feel an intense burning pain, as if their skin is going to catch fire. The military version had an output power of 100 kilowatts (kW), and a smaller law enforcement version, called Silent Guardian that was developed by Raytheon later, had an output power of 30 kW.
Clothing and other organic materials are transparent to millimeter waves of certain frequencies, so a recent application has been scanners to detect weapons and other dangerous objects carried under clothing, for applications such as airport security. Privacy advocates are concerned about the use of this technology because, in some cases, it allows screeners to see airport passengers as if without clothing.
The TSA has deployed millimeter wave scanners to many major airports.
Prior to a software upgrade the technology did not mask any part of the bodies of the people who were being scanned. However, passengers' faces were deliberately masked by the system. The photos were screened by technicians in a closed room, then deleted immediately upon search completion. Privacy advocates are concerned. "We're getting closer and closer to a required strip-search to board an airplane," said Barry Steinhardt of the American Civil Liberties Union. To address this issue, upgrades have eliminated the need for an officer in a separate viewing area. The new software generates a generic image of a human. There is no anatomical differentiation between male and female on the image, and if an object is detected, the software only presents a yellow box in the area. If the device does not detect anything of interest, no image is presented. Passengers can decline scanning and be screened via a metal detector and patted down.
Three security scanners using millimeter waves were put into use at Schiphol Airport in Amsterdam on 15 May 2007, with more expected to be installed later. The passenger's head is masked from the view of the security personnel.
According to Farran Technologies, a manufacturer of one model of the millimeter wave scanner, the technology exists to extend the search area to as far as 50 meters beyond the scanning area which would allow security workers to scan a large number of people without their awareness that they are being scanned.
Recent studies at the University of Leuven have proven that millimeter waves can also be used as a non-nuclear thickness gauge in various industries. Millimeter waves provide a clean and contact-free way of detecting variations in thickness. Practical applications for the technology focus on plastics extrusion, paper manufacturing, glass production and mineral wool production.
Low intensity (usually 10 mW/cm2 or less) electromagnetic radiation of extremely high frequency may be used in human medicine for the treatment of diseases. For example, "A brief, low-intensity MMW exposure can change cell growth and proliferation rates, activity of enzymes, state of cell genetic apparatus, function of excitable membranes and peripheral receptors." This treatment is particularly associated with the range of 40–70 GHz. This type of treatment may be called millimeter wave (MMW) therapy or extremely high frequency (EHF) therapy. This treatment is associated with eastern European nations (e.g., former USSR nations). The Russian Journal Millimeter waves in biology and medicine studies the scientific basis and clinical applications of millimeter wave therapy.
Police speed radar
- Electromagnetic shielding
- Journal of Infrared, Millimeter, and Terahertz Waves
- Knife-edge effect
- Terahertz radiation
- "Milestones: First Millimeter-wave Communication Experiments by J.C. Bose, 1894-96". List of IEEE milestones. Institute of Electrical and Electronics Engineers. Retrieved 1 October 2019.
- User Equipment (UE) radio transmission and reception; Part 3: Range 1 and Range 2 Interworking operation with other radios (PDF) (Technical Specification). 3GPP TS 38.101-3 version 15.2.0 Release 15. ETSI. July 2018. p. 11. Retrieved 5 December 2019.
- du Preez, Jaco; Sinha, Saurabh (2017). Millimeter-Wave Power Amplifiers. Springer. pp. 1–35. ISBN 978-3-319-62166-1.
- Huang, Kao-Cheng; Zhaocheng Wang (2011). Millimeter Wave Communication Systems. John Wiley & Sons. pp. Sections 1.1.1–1.2. ISBN 978-1-118-10275-6.
- "Millimeter Wave Propagation: Spectrum Management Implications" (PDF). Office of Engineering and Technology, Bulletin No. 70. Federal Communications Commission (FCC), US Dept. of Commerce. July 1997. Retrieved May 20, 2017. Cite journal requires
- du Preez, Jaco; Sinha, Saurabh (2016). Millimeter-Wave Antennas: Configurations and Applications. Springer. pp. 13–14. ISBN 978-3319350684.
- Seybold, John S. (2005). Introduction to RF Propagation. John Wiley and Sons. pp. 55–58. ISBN 0471743682.
- FCC.gov[permanent dead link], Comments of IEEE Geoscience and Remote Sensing Society, FCC RM-11104, 10/17/07
- Rfdesign.com Archived 2012-07-16 at the Wayback Machine, Multigigabit wireless technology at 70 GHz, 80 GHz and 90 GHz, RF Design, May 2006
- Rappaport, T.S.; Sun, Shu; Mayzus, R.; Zhao, Hang; Azar, Y.; Wang, K.; Wong, G.N.; Schulz, J.K.; Samimi, M. (2013-01-01). "Millimeter Wave Mobile Communications for 5G Cellular: It Will Work!". IEEE Access. 1: 335–349. doi:10.1109/ACCESS.2013.2260813. ISSN 2169-3536.
- Asadi, Arash; Klos, Sabrina; Sim, Gek Hong; Klein, Anja; Hollick, Matthias (2018-04-15). "FML: Fast Machine Learning for 5G mmWave Vehicular Communications". IEEE Infocom'18.
- "Slideshow: Say Hello to the Goodbye Weapon". Wired. 5 December 2006. Retrieved 16 August 2016.
- "Active Denial System: a terahertz based military deterrent for safe crowd control". Terasense Group Inc. 2019-05-29. Retrieved 2020-05-03.
- Hambling, David (2009-05-08). "'Pain ray' first commercial sale looms". Wired. Retrieved 2020-05-03.
- Newscientisttech.com Archived March 11, 2007, at the Wayback Machine
- Frank, Thomas (18 February 2009). "Body scanners replace metal detectors in tryout at Tulsa airport". USA Today. Retrieved 2 May 2010.
- "Statement of Robert Kane to House of Representatives" (PDF). 2011-11-03. p. 2. Archived from the original (PDF) on 2011-11-25.
- esa. "Bat inspires space tech for airport security". esa.int. Retrieved 7 April 2018.
- Pakhomov, A. G., Murphy, P. R. (2000). "Low-intensity millimeter waves as a novel therapeutic modality". IEEE Transactions on Plasma Science. 28 (1): 34–40. Bibcode:2000ITPS...28...34P. doi:10.1109/27.842821. S2CID 22730643.CS1 maint: uses authors parameter (link)
- Betskii, O. V., Devyatkov, N. D., Kislov, V. (2000). "Low Intensity Millimeter Waves in Medicine and Biology". Critical Reviews in Biomedical Engineering. Begellhouse.com. 28 (1&2): 247–268. doi:10.1615/CritRevBiomedEng.v28.i12.420. PMID 10999395.CS1 maint: uses authors parameter (link)
- M. Rojavin, M. Ziskin (1998). "Medical application of millimetre waves". QJM: An International Journal of Medicine. 91 (1): 57–66. doi:10.1093/qjmed/91.1.57. PMID 9519213.CS1 maint: uses authors parameter (link)
- Benran.ru Archived 2011-07-18 at the Wayback Machine
- "Radio and Radar Frequency Bands". copradar.com. Retrieved 30 April 2020.