Dynamic speaker with 4-pin connector
|Use||loudspeaker built into most IBM PC compatible computers|
A PC speaker is a loudspeaker built into some IBM PC compatible computers. The first IBM Personal Computer, model 5150, employed a standard 2.25 inch magnetic driven (dynamic) speaker. More recent computers use a piezoelectric speaker instead. The speaker allows software and firmware to provide auditory feedback to a user, such as to report a hardware fault. A PC speaker generates waveforms using the programmable interval timer, an Intel 8253 or 8254 chip.
BIOS error codes
The PC speaker is used during power-on self-test (POST) sequence to indicate errors during the boot process. Since it is active before the graphics card, it can be used to communicate "beep codes" related to problems that prevent the much more complex initialization of the graphics card to take place. For example, the Video BIOS usually cannot activate a graphics card unless working RAM is present in the system, while beeping the speaker is possible with just ROM and the CPU registers. Usually, different error codes will be signaled by specific beeping patterns, such as e.g. "one beep; pause; three beeps; pause; repeat". These patterns are specific to the BIOS manufacturer and are usually documented in the technical manual of the motherboard.
The PC speaker was often used in very innovative ways to create the impression of polyphonic music or sound effects within computer games of its era, such as the LucasArts series of adventure games from the mid-1990s, using swift arpeggios. Several games such as Space Hulk and Pinball Fantasies were noted for their elaborate sound effects; Space Hulk, in particular, even had full speech.
Several programs, including MP (Module Player, 1989), Scream Tracker, Fast Tracker, Impulse Tracker, and even device drivers for Linux and Microsoft Windows, could play pulse-code modulation (PCM) sound through the PC speaker using special techniques explained later in this article.
Modern Microsoft Windows systems have PC speaker support as a separate device with special capabilities – that is, it cannot be configured as a normal audio output device. Some software uses this special sound channel to produce sounds. For example, Skype can use it as a reserve calling signal device for the case where the primary audio output device cannot be heard (for example because the volume is set to the minimum level or the amplifier is turned off).
In some applications, the PC speaker is affixed directly to the computer's motherboard; in others, including the first IBM Personal Computer, the speaker is attached by wire to a connector on the motherboard. Some PC cases come with a PC speaker preinstalled. A wired PC speaker connector may have a two-, three-, or four-pin configuration, and either two or three wires. The female connector of the speaker connects to pin headers on the motherboard, which are sometimes labeled SPEAKER or SPKR.
|Pin Number||Pin Name||Pin Function|
|2||GND or KEY||Ground, or unwired key|
|4||+SP5V||Speaker positive +5V DC|
The PC speaker is normally meant to reproduce a square wave via only 2 levels of output (the speaker is driven by only two voltage levels, typically 0 V and 5 V). However, by carefully timing a short pulse (i.e. going from one output level to the other and then back to the first), and by relying on the speaker's physical filtering properties (limited frequency response, self-inductance, etc.), the end result corresponds to intermediate sound levels, functioning as a crude digital-to-analog converter. This technique is called pulse-width modulation (PWM) and allows approximate playback of PCM audio. (A more refined version of this technique is used in class D audio amplifiers.)
With the PC speaker, this method achieves limited quality playback; the quality depends on a trade-off between the PWM carrier frequency (effective sample rate) and the number of output levels (effective bitrate). The clock rate of the PC's programmable interval timer which drives the speaker is fixed at 1,193,180 Hz, and the product of the audio sample rate times the maximum DAC value must equal this. Typically, a 6-bit DAC with a maximum value of 63 is used at a sample rate of 18,939.4 Hz, producing poor but recognizable audio.
- "Specifications of the IBM 5150 PC" (PDF). Archived from the original on 22 February 2012. Retrieved 4 February 2011.CS1 maint: Unfit url (link)[not in citation given]
- Rosenthal, Morris (August 2008). Computer Repair with Diagnostic Flowcharts (Revised ed.). Foner Books. p. 9. ISBN 978-0-9723801-7-1.
- "The PIT: A System Clock". Osdever.net. Retrieved 4 February 2011.
- Sergeev, Stas. "PC-Speaker PCM driver for Linux". Archived from the original on 26 October 2009. Retrieved 15 February 2009.CS1 maint: Unfit url (link)
- Ögren, Joakim. "The Hardware Book" (PDF).
- ASUS P5KPL-AM SE Motherboard manual (PDF).
- Edward Schlunder (18 November 2006). "Resistor/Pulse Width Modulation DAC". Archived from the original on 17 March 2017.
- Smacky Open-source C++ software for playing songs on the PC speaker.
- Site for old PC without sound cards.
- PCGPE article on programming the PC Speaker.
- Part 1 of another article about programming the PC speaker.
- Part 2 of the article
(includes a very detailed explanation of how to play back PCM audio on the PC speaker, and why it works)
- Bleeper Music Maker A freeware to use the PC speaker to make music (superseded by BaWaMI)
- Article about programming PC speaker using C++
- Commandline PC speaker program for LinuxFTP
- Practical article on implementing a Linux Kernel Driver
- Timing on the PC family under DOS (Sections 7.5, 7.29, 7.30, and 10.7 – 10.7.4 in particular)