This article needs additional citations for verification. (December 2009) (Learn how and when to remove this template message)
An index register in a computer's CPU is a processor register or assigned memory location used for modifying operand addresses during the run of a program. This proved useful for doing vector/array operations and in commercial data processing for navigating from field to field within records. In both uses index registers substantially reduced the amount of memory used and increased execution speed.
The contents of an index register is added to (in some cases subtracted from) an immediate address (one that is part of the instruction itself) to form the "effective" address of the actual data (operand). Special instructions are typically provided to test the index register and, if the test fails, increments the index register by an immediate constant and branches, typically to the start of the loop. Some instruction sets allow more than one index register to be used; in that case additional instruction fields specify which index registers to use. While normally processors that allow an instruction to specify multiple index registers add the contents together, IBM had a line of computers in which the contents were or'd together.
In early computers without any form of indirect addressing, array operations had to be performed by modifying the instruction address, which required several additional program steps and used up more computer memory, a scarce resource in computer installations of the early era (as well as in early microcomputers two decades later).
Index registers, commonly known as a B-line in early British computers, were first used in the British Manchester Mark 1 computer, in 1949. In general, index registers became a standard part of computers during the technology's second generation, roughly 1954–1966. Most[a] machines in the IBM 700/7000 mainframe series had them, starting with the IBM 704 in 1954, though they were optional on some smaller machines such as the IBM 650 and IBM 1401.
While the Intel 8080 allowed indirect addressing via a register, the first microprocessor with a true index register appears to have been the Motorola 6800, and the similar MOS Technology 6502 made good use of two such registers.
Modern computer designs generally do not include dedicated index registers; instead they allow any general purpose register to contain an address, and allow a constant value and, on some machines, the contents of another register to be added to it as an offset to form the effective address. Early computers designed this way include the PDP-6 and the IBM System/360.
Here is a simple example of index register use in assembly language pseudo-code that sums a 100 entry array of 4-byte words:
Clear_accumulator Load_index 400,index2 //load 4*array size into index register 2 (index2) loop_start : Add_word_to_accumulator array_start,index2 //Add to AC the word at the address (array_start + index2) Branch_and_decrement_if_index_not_zero loop_start,4,index2 //loop decrementing by 4 until index register is zero
- The 702, 705 and 7080 did not have index registers.
- "Instructions: Index Words" (PDF). IBM 7070-7074 Principles of Operation (PDF). IBM. 1962. p. 11. GA22-7003-6.
- IBM 709 Reference Manual, Form A22-6501-0, 1958, p. 12
- IBM 7094 Principles of Operation (PDF). Fifth Edition. IBM. October 21, 1966. A22-6703-4.
- IBM 1401 Reference manual, Form A24-1403-4, 1960, p. 77