In materials science, fast ion conductors are solids with highly mobile ions. These materials are important in the area of solid-state ionics, and are also known as solid electrolytes and superionic conductors. These materials are useful in batteries and various sensors. Fast ion conductors are used primarily in solid oxide fuel cells. As solid electrolytes they allow the movement of ions without the need for a liquid or soft membrane separating the electrodes. The phenomenon relies on the hopping of ions through an otherwise rigid crystal structure.
Fast ion conductors are intermediate in nature between crystalline solids which possess a regular structure with immobile ions, and liquid electrolytes which have no regular structure and fully mobile ions. Solid electrolytes find use in all solid-state supercapacitors, batteries, and fuel cells, and in various kinds of chemical sensors.
In solid electrolytes (glasses or crystals), the ionic conductivity Ωi can be any value, but it should be much larger than the electronic one. Usually, solids where Ωi is on the order of 0.0001 to 0.1 Ohm−1 cm−1 (300 K) are called superionic conductors.
Unlike conventional solid electrolytes and superionic conductors.
Superionic conductors where Ωi is more than 0.1 Ohm−1 cm−1 (300 K) and the activation energy for ion transport Ei is small (about 0.1 eV), are called advanced superionic conductors. The most famous example of advanced superionic conductor-solid electrolyte is RbAg4I5 where Ωi > 0.25 Ohm−1 cm−1 and Ωe ~10−9 Ohm−1 cm−1 at 300 K. The Hall (drift) ionic mobility in RbAg4I5 is about 2×10−4 cm2/(V•s) at room temperatures. The Ωe – Ωi systematic diagram distinguishing the different types of solid-state ionic conductors is given in the figure.
No clear examples have been described as yet, of fast ion conductors in the hypothetical advanced superionic conductors class (areas 7 and 8 in the classification plot). However, in crystal structure of several superionic conductors, e.g. in the minerals of the pearceite-polybasite group, the large structural fragments with activation energy of ion transport Ei < kBT (300 К) had been discovered in 2006.
A common solid electrolyte is yttria-stabilized zirconia, YSZ. This material is prepared by doping Y2O3 into ZrO2. Oxide ions typically migrate only slowly in solid Y2O3 and in ZrO2, but in YSZ, the conductivity of oxide increases dramatically. These materials are used to allow oxygen to move through the solid in certain kinds of fuel cells. Zirconium dioxide can also be doped with calcium oxide to give an oxide conductor that is used in oxygen sensors in automobile controls. Upon doping only a few percent, the diffusion constant of oxide increases by a factor of ~1000.
Another example of a popular fast ion conductor is beta-alumina solid electrolyte. Unlike the usual forms of alumina, this modification has a layered structure with open galleries separated by pillars. Sodium ions (Na+) migrate through this material readily since the oxide framework provides an ionophilic, non-reducible medium. This material is considered as the sodium ion conductor for the sodium–sulfur battery.
Fluoride ion conductors
Lanthanum trifluoride (LaF3) is conductive for F− ions, used in some ion selective electrodes. Beta-lead fluoride exhibits a continuous growth of conductivity on heating. This property was first discovered by Michael Faraday.
A textbook example of a fast ion conductor is silver iodide (AgI). Upon heating the solid to 146 °C, this material adopts the alpha-polymorph. In this form, the iodide ions form a rigid cubic framework, and the Ag+ centers are molten. The electrical conductivity of the solid increases by 4000x. Similar behavior is observed for copper(I) iodide (CuI), rubidium silver iodide (RbAgI2), and Ag2HgI4.
Other Inorganic materials
- Silver sulfide, conductive for Ag+ ions, used in some ion selective electrodes
- Lead(II) chloride, conductive at higher temperatures
- Some perovskite ceramics – strontium titanate, strontium stannate – conductive for O2− ions
- Zr(HPO4)2.nH2O – conductive for H+ ions
- UO2HPO4.4H2O (hydrogen uranyl phosphate tetrahydrate) – conductive for H+ ions
- Cerium(IV) oxide – conductive for O2− ions
- Many gels, such polyacrylamides, agar, etc. are fast ion conductors
- A salt dissolved in a polymer – e.g. lithium perchlorate in polyethylene oxide
- Polyelectrolytes and Ionomers – e.g. Nafion, a H+ conductor
The important case of fast ionic conduction is one in a surface space-charge layer of ionic crystals. Such conduction was first predicted by Kurt Lehovec. As a space-charge layer has nanometer thickness, the effect is directly related to nanoionics (nanoionics-I). Lehovec's effect is used as a basis for developing nanomaterials for portable lithium batteries and fuel cells.
- Stuhrmann C.H.J.; Kreiterling H.; Funke K (2002). "Ionic Hall effect measured in rubidium silver iodide". Solid State Ionics. 154–155: 109–112. doi:10.1016/S0167-2738(02)00470-8.
- Александр Деспотули; Александра Андреева (2007). Высокоёмкие конденсаторы для 0,5 вольтовой наноэлектроники будущего. Современная Электроника (Portable Document Format) (in Russian). http://www.nanometer.ru/2007/10/17/nanoionnie_superkondensatori_4879/PROP_FILE_files_1/Despotuli_Andreeva_Modern_Electronics_2007.pdf (7): 24–29. Alexander Despotuli; Alexandra Andreeva (2007). "High-capacity capacitors for 0.5 voltage nanoelectronics of the future". Modern Electronics (Portable Document Format). http://www.nanometer.ru/2007/10/17/nanoionnie_superkondensatori_4879/PROP_FILE_files_2/Despotuli_Andreeva_Modern_Electronics_2007(ENG).pdf (7): 24–29.
- Despotuli, A.L.; Andreeva, A.V. (January 2009). "A Short Review on Deep-Sub-Voltage Nanoelectronics and Related Technologies". Int. J. Nanoscience. 8 (4&5): 389–402. Bibcode:2009IJN.....8..389D. doi:10.1142/S0219581X09006328.
- Bindi, L.; Evain M. (2006). "Fast ion conduction character and ionic phase-transitions in disordered crystals: the complex case of the minerals of the pearceite– polybasite group". Phys Chem Miner. 33: 677–690. Bibcode:2006PCM....33..677B. doi:10.1007/s00269-006-0117-7.
- Shriver, D. F.; Atkins, P. W.; Overton, T. L.; Rourke, J. P.; Weller, M. T.; Armstrong, F. A. “Inorganic Chemistry” W. H. Freeman, New York, 2006. ISBN 0-7167-4878-9.
- Greenwood, Norman N.; Earnshaw, Alan (1997). Chemistry of the Elements (2nd ed.). Butterworth-Heinemann. ISBN 0-08-037941-9.
- "The Roll-to-Roll Battery Revolution". Ev World. Retrieved 2010-08-20.
- Perzyna, K.; Borkowska, R.; Syzdek, J. A.; Zalewska, A.; Wieczorek, W. A. A. (2011). "The effect of additive of Lewis acid type on lithium–gel electrolyte characteristics". Electrochimica Acta. 57: 58. doi:10.1016/j.electacta.2011.06.014.
- Syzdek, J. A.; Armand, M.; Marcinek, M.; Zalewska, A.; Żukowska, G. Y.; Wieczorek, W. A. A. (2010). "Detailed studies on the fillers modification and their influence on composite, poly(oxyethylene)-based polymeric electrolytes". Electrochimica Acta. 55 (4): 1314. doi:10.1016/j.electacta.2009.04.025.
- Lehovec, Kurt (1953). "Space-charge layer and distribution of lattice defects at the surface of ionic crystals". Journal of Chemical Physics. 21 (7): 1123–1128. Bibcode:1953JChPh..21.1123L. doi:10.1063/1.1699148.