This article has multiple issues. Please help improve it or discuss these issues on the talk page. (Learn how and when to remove these template messages)(Learn how and when to remove this template message)
Acoustic waves are a type of energy propagation through a medium by means of adiabatic compression and decompression. Important quantities for describing acoustic waves are acoustic pressure, particle velocity, particle displacement and acoustic intensity. Acoustic waves travel with a characteristic acoustic velocity that depends on the medium they're passing through. Some examples of acoustic waves are audible sound from a speaker (waves traveling through air at the speed of sound), ground movement from an earthquake (waves traveling through the earth), or ultrasound used for medical imaging (waves traveling through the body).
This section does not cite any sources. (July 2020) (Learn how and when to remove this template message)
Acoustic wave equation
- is sound pressure in Pa
- is position in the direction of propagation of the wave, in m
- is speed of sound in m/s
- is time in s
The wave equation for particle velocity has the same shape and is given by
For lossy media, more intricate models need to be applied in order to take into account frequency-dependent attenuation and phase speed. Such models include acoustic wave equations that incorporate fractional derivative terms, see also the acoustic attenuation article.
D'Alembert gave the general solution for the lossless wave equation. For sound pressure, a solution would be
For the wave becomes a travelling wave moving rightwards, for the wave becomes a travelling wave moving leftwards. A standing wave can be obtained by .
In a travelling wave pressure and particle velocity are in phase, which means the phase angle between the two quantities is zero.
This can be easily proven using the ideal gas law
Consider a volume . As an acoustic wave propagates through the volume, adiabatic compression and decompression occurs. For adiabatic change the following relation between volume of a parcel of fluid and pressure holds
- is the adiabatic index without unit and the subscript denotes the mean value of the respective variable.
As a sound wave propagates through a volume, the horizontal displacement of a particle occurs along the wave propagation direction.
- is cross-sectional area in m2
From this equation it can be seen that when pressure is at its maximum, particle displacement from average position reaches zero. As mentioned before, the oscillating pressure for a rightward travelling wave can be given by
Since displacement is maximum when pressure is zero there is a 90 degrees phase difference, so displacement is given by
Particle velocity is the first derivative of particle displacement: . Differentiation of a sine gives a cosine again
During adiabatic change, temperature changes with pressure as well following
This fact is exploited within the field of thermoacoustics.
The propagation speed, or acoustic velocity, of acoustic waves is a function of the medium of propagation. In general, the acoustic velocity c is given by the Newton-Laplace equation:
- C is a coefficient of stiffness, the bulk modulus (or the modulus of bulk elasticity for gas mediums),
- is the density in kg/m3
Thus the acoustic velocity increases with the stiffness (the resistance of an elastic body to deformation by an applied force) of the material, and decreases with the density. For general equations of state, if classical mechanics is used, the acoustic velocity is given by
where differentiation is taken with respect to adiabatic change.
- where is the pressure and is the density
This section needs additional citations for verification. (July 2020) (Learn how and when to remove this template message)
Acoustic waves are elastic waves that exhibit phenomena like diffraction, reflection and interference. Note that sound waves in air are not polarized since they oscillate along the same direction as they move.
Interference is the addition of two or more waves that results in a new wave pattern. Interference of sound waves can be observed when two loudspeakers transmit the same signal. At certain locations constructive interference occurs, doubling the local sound pressure. And at other locations destructive interference occurs, causing a local sound pressure of zero pascals.
A standing wave is a special kind of wave that can occur in a resonator. In a resonator superposition of the incident and reflective wave occurs, causing a standing wave. Pressure and particle velocity are 90 degrees out of phase in a standing wave.
Consider a tube with two closed ends acting as a resonator. The resonator has normal modes at frequencies given by
At the ends particle velocity becomes zero since there can be no particle displacement. Pressure however doubles at the ends because of interference of the incident wave with the reflective wave. As pressure is maximum at the ends while velocity is zero, there is a 90 degrees phase difference between them.
An acoustic travelling wave can be reflected by a solid surface. If a travelling wave is reflected, the reflected wave can interfere with the incident wave causing a standing wave in the near field. As a consequence, the local pressure in the near field is doubled, and the particle velocity becomes zero.
Attenuation causes the reflected wave to decrease in power as distance from the reflective material increases. As the power of the reflective wave decreases compared to the power of the incident wave, interference also decreases. And as interference decreases, so does the phase difference between sound pressure and particle velocity. At a large enough distance from the reflective material, there is no interference left anymore. At this distance one can speak of the far field.
The amount of reflection is given by the reflection coefficient which is the ratio of the reflected intensity over the incident intensity
Acoustic waves can be absorbed. The amount of absorption is given by the absorption coefficient which is given by
Often acoustic absorption of materials is given in decibels instead.
When an acoustic wave propagates through a non-homogeneous medium, it will undergo diffraction at the impurities it encounters or at the interfaces between layers of different materials. This is a phenomenon very similar to that of the refraction, absorption and transmission of light in Bragg mirrors. The concept of acoustic wave propagation through periodic media is exploited with great success in acoustic metamaterial engineering.
- Acoustic attenuation
- Acoustic metamaterial
- Auditory imagery
- Audio signal processing
- Doppler effect
- Gravity wave
- Musical note
- Musical tone
- Physics of music
- Signal tone
- Sound localization
- Stereo imaging
- Structural acoustics
- List of unexplained sounds
- Gorishnyy, Taras, Martin Maldovan, Chaitanya Ullal, and Edwin Thomas. "Sound ideas." Physics World 18, no. 12 (2005): 24.
- Laude, Vincent (2015-09-14). Phononic Crystals: Artificial Crystals for Sonic, Acoustic, and Elastic Waves. Walter de Gruyter GmbH & Co KG. ISBN 978-3-11-030266-0.